Instruction manual

34
IMAGE CORRECTION – VARIATIONS
2. Click on the appropriate window or
move the sliders to increase or
decrease the contrast and/or
brightness.
• The changes are automatically applied to the preview
image.
• Additional contrast and brightness simulations will be
mapped around the center image.
Adjusting the Brightness and Contrast
The image simulation windows map contrast and brightness changes to the preview image.
The windows display a one step change in the brightness and contrast, but up to 10 steps (+/-)
can be applied. The selected colour, brightness, and contrast changes are automatically
applied to the preview image
Correcting the brightness
and contrast may
eliminate the need for
colour corrections.
3. Adjust the colour balance as necessary by
clicking on the R, G, and B sliders.
• R can subtract red (left arrow) or subtract cyan (right arrow).
• G can subtract green (left arrow) or subtract magenta (right
arrow).
• B can subtract blue (left arrow) or subtract yellow (right arrow).
Adjusting the Colour
4. Click on to apply the changes to your
scan.
• Click on to cancel all corrections and start over.
• Click on to close the variations window without applying any
corrections.
Applying the Corrections