Hardware manual

SCANNER NOTES
16
Quit the DiMAGE Scan Utility. Confirm that the scanner indicator lamp is not blinking. Turn the
scanner off and then disconnect the cable.
Disconnecting the USB cable
Never disconnect the scanner when the indicator
lamp is blinking.
Disconnecting the scanner
The easiest and safest way to disconnect the scanner from the computer is to turn off both
devices as well as any peripheral devices and remove the cable. However, the following proce-
dures can be used depending on the cable and operating system employed.
When the DiMAGE Scan Utility is installed, the scanner profiles listed below are automatically
installed in the color folder in Windows, and in the ColorSync profile folder in Macintosh. These
profiles have been included for advanced color matching with profile-to-profile conversions in
sophisticated image-processing or DTP applications. When using these profiles, the color repro-
duced may not be the same as the color matching system in the utility software.
MLTAF2920.icc - used with positive film at any color depth other than 16-bit linear.
MLTAF2920p.icc - used with positive film with 16-bit linear color depth.
Scanner color profiles
Scanner resolution
The maximum resolution for the DiMAGE Scan Elite II is 2820 dpi. The input resolution that can
be entered in the DiMAGE Scan Utility is from 176 dpi to the maximum resolution of 2820 dpi for
both 35mm and APS film.
Disconnecting the IEEE cable with 2000 professional, XP, and Macintosh
Quit the DiMAGE Scan Utility. Confirm that the scanner indicator lamp is not blinking. Turn the
scanner off and then disconnect the cable.