Service manual
Table Of Contents
- Specifications
- Scanner Type
- Usable Film Type
- Scanning Dimension
- Optical Resolution
- Scanning method
- Image Sensor
- Scan Time (excluding the data transfer time to PC)
- AD Conversion
- Output
- Dynamic Range
- Light Source
- Focus
- Others
- Interface
- Power Requirements
- Power Consumption
- Size
- Weight
- Standard Accessory
- Operating Environment
- Storage Environment
- System Requirements
- Parts List
- Repair Guide
- Checklist
- 2890plu.pdf
- 2890rg_eu.pdf
- 2890cl_eu.pdf
(2890) B6
REPAIR GUIDE
Connect the connector by the position as shown.
The red / brown solenoid
Red / orange Power SW
Red / black inverter PCB
Main PCB
Bottom cover
Coil installation.
Coil
Install a coil into the bottom cover.
Arm installation.
Install the arm notch aligning with the Image taking unit.
(in the circle)
Power SW SP
Arm
Serial number installation.
Stick onto the center of the posts.
Rating label installation.
Stick a rating label as shown in the figure after fixing
top cover with screws.
Do not let it run over the top cover.
9384-2191-01(10x30mm)
" Fig. 6
" Fig. 5" Fig. 4
" Fig. 7 " Fig. 8
B-51
After installing the coil on the lower case with 9384-2191-01,
apply B-51 into the shaded area to prevent the coil from
detaching.
Coil