Instruction Manual

BASIC RECORDING PROCEDURE - CONT’D
- 33 -
Press the shutter-release button
part-way down.
• The camera adjusts the focus
automatically. When the subject is focused,
the focus lamp (green) lights up.
• When the focus lamp (green) blinks, follow
the operation from step again.
• When the flash will fire, the flash lamp
(orange) lights up.
• When the flash lamp (orange) blinks slowly
(about 2 times in a second), the shutter
speed becomes slow. Taking a picture in
this mode may cause an image blurred.
We recommend you to take pictures after
fixing the camera on the tripod.
Press the shutter-release button
the rest of the way down.
• If the flash lamp (orange) blinks when the
shutter-release button is pressed all the
way down, the flash is being charged.
When the shutter-release button is kept
pressed in this status, the shutter is
released at the same time when the flash
is charged.
• The captured image is displayed on the
LCD monitor and is recorded in the CF
card. While the image is recorded, the
focus lamp (green) blinks slowly (about 2
times in a second) and “RECORDING”
blinks on the LCD monitor slowly. Be sure
not to open the battery- chamber door,
disconnect the plug of the AC adapter
or remove the CF card until the
recording in the CF card is completed
(until the focus lamp (green) and
“RECORDING” stops blinking). The data
in the CF card may be damaged or lost.
* When pressing the shutter-
release button, there is a
point where the button
stops halfway. To press the
shutter-released button to
this point is described
“Press part-way down” in
this manual.
D2330Z_Body_Eng.qxd.4 00.10.11 5:22 PM ページ 33