Instruction Manual

TROUBLESHOOTING - CONT’D
- 150 -
Problem
The image
cannot be
played back
on the LCD
monitor.
The image
recorded in
the flash
mode is dark.
Page
71
24
27
24
28
27
15
41
Solution
Rotate the function dial to
and slide the power switch to
turn on the camera.
Replace all four batteries or
use the AC adapter (sold
separately).
Remove the batteries and
then insert the batteries by
following the +/– diagram
indicated in front of the
battery-chamber door.
When “NO CARD” is
displayed on the LCD
monitor and “CF” is displayed
on the data panel, the CF
card is not set. Insert the CF
card.
Slide the power switch to turn
on the camera again.
The camera reads out the
image data from the CF card.
Wait until the reading is
completed and the focus
lamp and “PLAY BACK” stop
blinking.
Take a picture within the
flash range (0.4 to 3 m).
Check
Is the power of the
camera turned off?
Are the batteries
exhausted?
Are the batteries
inserted with the
correct polarity?
Is the CF card is
inserted in the
camera? (Is “NO
CARD” displayed on
the LCD monitor?)
The auto power off
function activates.
Is the focus lamp
(green) blinks slowly
(about 2 times in a
second) and “PLAY
BACK” blinks on the
LCD monitor?
Did you take a picture
within the flash range?
D2330Z_Body_Eng.qxd.4 00.10.11 5:23 PM ページ 150