Service manual

D-4
No. Part Name Removal Procedure
1 Original Glass Remove No.3.
2 EDH Glass Remove No.3.
3 EDH Glass Holder Raise No.13. → Remove four EDH Glass Holder mounting
screws.
4 Control Panel Raise No.13. → Swing down No.5. → Remove No.18. → Remove
No.11. → Remove five Control Panel mounting screws. → Unplug
two connectors.
5 Front Door Swing down the Front Door. → Remove two Front Door hinge
shafts. → Remove two belt mounting screws inside the Front
Door.
6 1st Drawer Slide out the drawer. → Remove one screw and the right stopper.
→ Pressing the tab on the left rail, pull out the drawer.
7 2nd Drawer
8 Middle Left Door Remove No.11. → Remove two Middle Left Door mounting
screws.
9 Upper Left Door
(Exit/Duplex
Switching Unit)
☞ D-17
10 Filter Cover Unhook one tab on the Filter Cover.
11 Left Cover Slide out No.6. → SwingdownNo.5.→ Remove seven Left Cover
mounting screws.
12 Rear Upper Cover Remove No.13. → Remove No.11. → Remove No.18. → Remove
two Rear Upper Cover mounting screws.
13 Original Cover Remove the Original Cover by pulling up.
14 Rear Cover Remove nine Rear Cover mounting screws.
15 Connector Cover Remove one Connector Cover mounting screws.
16 Upper Right Door
(Multi Bypass
Unit)
☞ D-9
17 Counter Cover Unhook two tabs on the Counter Cover.
18 Right Cover Slide out No.6. → Swing down No.5. → Open No.16. → Open the
Multi Bypass Table. → Remove seven Right Cover mounting
screws.