Service manual

S-44
Touch Panel
Display
Setting (The default is ).
Leading Edge
Erase
Select whether to enable or disable the leading edge erase.
Trailing Edge
Erase
Select whether to enable or disable the trailing edge erase.
Loop Adjustment Set the length of the loop to be formed in paper before the Synchro-
nizing Rollers.
VG Adjust Vary the Vg voltage to set the desired image density.
Zoom (CD) Set the correction value for the zoom ratio in the CD direction on the
IR side.
Zoom (FD)/Manual Set the correction value for the zoom ratio in the FD direction on the
IR side.
Scale (FD) Set the correction value for the start-of-scan position of the original in
the FD direction with respect to the Original Width Scale position.
Scale (CD) Set the correction value for the start-of-scan position of the original in
the CD direction with respect to the Original Length Scale position.
Zoom (FD) EDH Set the correction value for the zoom ratio in the FD direction when
the EDH is used.
Feed (2) Set the correction value for the original scanning position for the sec-
ond page of a 2-sided original when the EDH is used.
Highlighted
0to5( )
3mm
0to5( )
3mm
Setting
-3 ................................... ..................................+3
Description
Smaller Greater
0
Setting
-4 ................................... ..................................+4
Description
Lighter Darker
0
0.990 to 1.010 ( )
1.000
0.990 to 1.010 ( )
1.000
-4.0 to +4.0 ( )
0.0 mm
-10.0 to +10.0 ( )
0.0 mm
0.980 to 1.020 ( )
1.000
-5.0 to +5.0 ( )
0.0 mm