Service manual

S-30
Touch Panel
Display
Setting
PM
✽ See MAINTENANCE SCHEDULE (machine/options) for the appli-
cable parts.
Consumables Enter the count of the Waste Toner and Web Roller counters. When
the count reaches the set value, the maintenance code is displayed.
<Procedure>
1. Touch “Set”.
2. Press the Clear key to clear the current value.
Press the Interrupt key to undo the clearing operation, restoring
the original value.
3. Enter the value from the 10-Key Pad.
4. Touch “END”.
Trouble Counts the number of malfunctions that have occurred at different
parts of the copier.
Display Description
Staple 1
Staple 2
Punch
Sort/Group
Trans./Sepa. pass
Ozone Filter
No. of stapling sequences performed
No. of stapling sequences performed (FN-105)
No. of holes made (FN-105)
No. of copies fed out in the Sort/Group mode
No. of times a sheet of paper is fed through
No. of times a sheet of paper is fed through
Waste Toner: Maintenance code “M2”
Description Maintenance code Machine stop
Initial set
value
45 cpm Approx. 220 k 45 cpm
55 cpm Approx. 270 k 55 cpm
If the initial
set value is
changed
45 cpm
The set value -
Approx. 20 k
45 cpm Set value
55 cpm
The set value -
Approx. 30 k
55 cpm Set value
Web: Maintenance code “M3”
Description Maintenance code Machine stop
Initial set
value
45 cpm 460 k 45 cpm
55 cpm 470 k 55 cpm
If the initial
set value is
changed
When the count reaches
the set value
45 cpm 480 k
55 cpm 500 k
Approx. 240 k
Approx. 300 k
480 k
500 k
✽ “-”: Subtract
Malfunction
Code
Description
Malfunction
Code
Description
C0000 Main Drive Motor C004C Ventilation Fan
C0010 PC Drum Drive Motor C0045 Image Unit Cooling Fan
C0040 Suction Fan C0046 PH Cooling Fan 1
C0044 EDH Cooling Fan C0047 PH Cooling Fan 2