Service manual

D-93
(10) Erasure Width
Requirement
Adjust so that no shade of the Original Scale is produced on the sample copy.
This adjustment must be made when a shadow is produced from the Original Scale.
Adjustment Procedure
1. Call the Tech. Rep. mode to the screen.
2. Touch [I.R. (EDH) Check].
3. Touch [Tech. Rep. Choice].
4. Touch [Erasure Width].
7. Touch [END] to validate the setting value.
8. Go back to the Basic screen.
9. Set Lead Edge Erase to 0.
☞ D-87
NOTE
Be sure to record to current setting value.
10. Go back to the Basic screen.
Adjust Mode Setting Range
Erasure Width 0 to 5
5. Press the Clear key to clear the current
setting value.
4
7
5
8
0
3
6
9
C
12
4002D519AA
Usetoclearthe
setting value.
Usetoenterthe
setting value.
6. Using the 10-Key Pad, set “3” for Erasure
Width.
4002D533CA
Setting Value