Service manual

D-89
(8) Trail Edge Erase
Requirement
This adjustment must be made after the PH Unit has been replaced and following Registra-
tion (CD/FD).
Adjustment Procedure
1. Call the Adjust mode to the screen.
2. Touch [Printer].
3. Touch [Trail Edge Erase].
4. Press the Start Key to let the copier produce a test pattern.
5. Check to see if width A on the test pattern is up to the specifications. If it is outside the
specified range, perform the following adjustment steps.
Specification Adjust Mode Setting Range
3.0 ± 1.0 mm Trail Edge Erase 0 to 5
Width A on the test pattern output should fall within the
following range.
NOTE
The measurement shall be taken at the center on the
trailing edge of the paper.
1155D157AB