Operator`s manual

3-39
6. Selecting the Original Copy Type
Making Copies
Chapter 3
[Margin] key for the original:
When you're going to make copies using Single-
Sided Double-Sided or Double-Sided Single-
Sided, first check to see if your original has a file
margin in it. The machine can correct the margin
position to make good copies as long as you
instruct it properly.
Touch [Margin].
Select the desired margin position.
You have a choice of the following two
Margin Positions.
Hold down [
▼
]or[
▲
] until the desired
margin width is reached.
Useful Tip
You can change the margin width in 1/16
increments within the range 0 to 3/4.
Touch [Enter].
Useful Tips
• If the margin position is set to Left and width to
0, the image on both the front and back sides of
the copy has the same orientation as that on the
original.
• If the margin position is set to Top and width to
0,theimageonthe2ndsideofthecopyis
inverted to that on the 1st side.
It's not necessary to correct the margin position
and width if your original has no file margin.
If your original has a file margin
▼ ▼
1155O735AA
Original with a File Margin Original with no File Margin
1
4003P054CA
2
1155O636AA
• Margin Position (Left)
Orig. Copy
1155O635AA
• Margin Position (Top)
Orig. Copy
If your original has no file margin
3
4003P355EA
4
4002O013AB
Orig. Copy
4002O048AB
Orig. Copy
▼
Downloaded From ManualsPrinter.com Manuals