Operator`s manual

3-23
5. Selecting the Finishing
Making Copies
Chapter 3
<Only when the Finisher FN-5/ Finisher FN-105/
Mailbin Finisher is mounted>
Touch the desired finishing function key and
then touch [Hole Punch].
<For United States and Canada Users>
<Except United States and Canada Users>
NOTES
•Papersize
Finisher FN-5 :11
×
17L to Letter
Finisher FN-105 :11
×
17L to Letter
Mailbin Finisher :11
×
17L to Letter
• Hole Punch is not possible in the Interrupt
mode.
• When making copies in the Hole Punch mode,
make sure to load the originals into the
Electronic Document Handler or place the
Originals on the original Glass in the correct
direction.
☞
p.3-33
<For United States and Canada Users>
<Only when the Finisher FN-5 is mounted>
• The number of punch holes can be changed
between “2-Hole” and “3-Hole” by using the
Knob located inside the Finisher.
*When changing the setting for the number of
holes to be made, be sure the marks are
aligned.
.
Pull out Knob: 2-Hole
Push in Knob: 3-Hole
*The number of punch holes can be graphically
identified on the Touch Panel.
Useful Tips
• If you do not select a hole-punching position,
the machine automatically sets the Hole Punch
position according to the original feeding
direction as illustrated below.
• When making copies from either the 11
×
17L or
Legal L size, the machine automatically
specifies the hole punching position as shown
below.
Hole Punch
1
4003P331EA
4003P031DA
Knob
4002O295EA
Orig.
Copy
1155O789EA
Orig.
Copy
1155O790EA
1155O791EA
Orig.
Copy
Downloaded From ManualsPrinter.com Manuals