Operator`s manual

2-14
Getting to Know Your Machine
Chapter 2
4. Control Panel Keys and Indicators
Control Panel Keys and Indicators
Touch Panel
• Shows various screens and messages.
See: Using the Touch Panel ☞ p.2-16
Start Key
• Press to start a scanning cycle.
• Press to start a print cycle.
• Lights up green to accept a print command;
lights up orange to reject one.
10-Key Pad
• Use to set the number of copies to be made.
• Use to set the various numeric values.
Clear Key
• Press to reset the multi-copy entry to 1.
• Press to clear a zoom ratio entered when setting
one from the 10-Key Pad.
• Press to clear the original count, image data
scanned, and Access code.
Stop Key
• Press to stop a print cycle.
• Press to stop a scanning cycle.
Scan Key
• Press to select the Scanner mode.
* See the operator’s manual for the Scanner
for details.
Copy Key
• Press to select the Copy mode.
Access Key
• Press to enter the access number.
☞ p. 2-20
* This key becomes valid only when Copy
Track of the Administrator mode available
from User’s Choice is set.
Energy Saver Key
• Press to set the machine into the Energy Saver
mode.☞ p. 2-19
HDD Lamp
• Lights up to indicate that the Hard Disk Drive
Kit is being accessed.
Interrupt Key
• Press to select the Interrupt mode.
• Press it again to return to the previous job.
☞ p. 2-20
• Press to stop a multi copy cycle (except when the
machine is in an interrupt mode).
• Lights up to indicate that the machine is in the
Interrupt mode.
Panel Reset Key
• Press to set the machine into the initial mode,
clearing all settings made on the control panel.
(It also clears a job setup being currently made.)
☞ p. 2-19
* It does not, however, clear the contents of
the zoom and job program memory,
Interrupt mode, and the job held in reserve.
13
17 18 19 20
16
1514
1
2
3
4
5
6
7
8
9
10
11
12
Downloaded From ManualsPrinter.com Manuals