Operator`s manual

6-9
3. When the Message “Stapler is empty.” Appears
When a Message Appears
Chapter 6
NOTE
Check that no portion of the staple sheet hangs
out of the cartridge. Break off any portion of the
sheet that hangs out of the cartridge.
InsertthenewStapleCartridgeuntilaclick
is heard.
Push the Staple Unit back in and close the
Front Door.
Slide the Finisher back against the machine.
Touch [Staple] shown on the Touch Panel
and the machine automatically feeds a sheet
of paper to test the stapling.
Remove the sheet of paper to check that it
has been properly stapled.
* If no staples are evident, clear the staple
misfed.
“Clearing the Staple Misfeed.” ☞ p. 6-38
NOTES
• Reload the Staple Cartridge only after you are
prompted to do so by the message. Removing
the Staple Cartridge before then will result in
stapling trouble.
• After a new Staple Cartridge has been installed,
be sure to run a test-stapling sequence to
ensure that staples are properly driven into the
paper.
1134O076AA
6
1155O070AA
7
1155O071AA
8
4002O188AC
9
4003P188CA
10
1155O644AC
Downloaded From ManualsPrinter.com Manuals