Operator`s manual

5-22
5. Administrator Mode
Using the Utility Mode
Chapter 5
An access code can be programmed when “100 Accounts” is selected.
To show [Copy Track] on the Touch Panel,
follow the steps given in “Selecting the
Administrator Mode.”☞p.5-18
Touch [Copy Track Data].
Select the page number on which the target
account is shown.
Touch the Access Code key of the target
account.
Enter the administrator number from the 10-
Key Pad and touch [Enter].
NOTES
• The access code should be a 4-digit number.
• To correct a number entry, press the Clear key
and then enter the new number.
• If you want to program an access code for
another account, repeat steps 3 through 5.
• If a new access code is programmed, the old
one is erased.
• If a new access code entered already exists for
another account, the entry is rejected. Enter a
different access code.
Touch [Enter].
Useful Tip
The account number may be changed by
touching the corresponding No. key and using the
10-Key Pad. If the account number newly entered
already exists, that entry is canceled.
Programming the Access Code
1
2
4003P478EB
3
4003P479EA
4
4003P180CA
5
1149O243AB
6
4003P560EA
Downloaded From ManualsPrinter.com Manuals