Operator`s manual

5-16
4. User’s Choice
Using the Utility Mode
Chapter 5
[5/6]
Select either “Auto Detect” or “Size Input” for the
size of the paper loaded in the Universal Tray.
The initial settings are as follows:
1st Drawer: “Auto Detect”
2nd Drawer: “Auto Detect”
Designate a drawer for special paper.
The initial setting is “Normal” for all drawers.
See p. 3-10 for Special Paper Setting.
Select the time it takes the auto panel reset
function to be activated from among “30 seconds,”
“1 min.,” “2 min.,” “3 min.,” or “5 min.,” or not
activate the function at all (“No Reset”).
The initial setting is “1 min.”
Set the time it takes the machine to enter the
Energy Saver mode, from 1 min. to 90 min. (in 1
min. increments).
The initial setting is “15 min.”
Select whether to reset the panel (“ON”) or not
(“OFF”) when the Plug-In Counter is pulled out of
the machine.
The initial setting is “ON.”
<Only when the Printer Controller is not
mounted>
Auto Shut Off shuts down the machine a given
period of time after the last operation.
Select the time it takes the Auto Shut Off function
tobeactivated,from15min.to90min.in1min.
increments.
The initial setting is “90 min.”
* A setting is also possible to disable Auto Shut
Off.
<Only when the Printer Controller is mounted>
Select the time it takes the machine to
automatically enter the Sleep mode from 15 to 90
min. in 1 min increments.
The initial setting is “90 min.”
* The Sleep function can even be disabled.
[6/6]
Set the date and time-of-day.
The initial setting is “2000/10/01,00:00:00.”
Select the print exposure level from among
“Lighter,” “Normal,” or “Darker.”
The initial setting is “Normal.”
Select the configuration of the machine, either as a
“Copier” or “Printer.”
The initial setting is “Copier.”
Select the image density level when the Electronic
Document Handler is used, either Mode 1 or Mode 2.
Select the density level according to the original,
either “Mode 1” or “Mode 2.”
The initial setting is “Mode 2.”
Mode 1: Used for the standard original, such as a
word-processor made document.
Mode 2: Effective in reproducing a pale original,
such as a faint pencil-written document.
<Only when the Finisher FN-105, Finisher FN-
106 or Finisher FN-5 is mounted>
Select the output tray into which copied paper is to
be fed, either “Top Tray” or “Bottom Tray.”
The initial setting is “Top Tray.”
Universal Tray
Special Paper
Auto Panel Reset
Energy Save Mode
Plug-In Counter Reset
Auto Shut Off
Sleep
Date/Time Set
Print Exposure
Priority Device
Density (ADF)
Priority Offset Tray
:Mode1
: Mode 2
Downloaded From ManualsPrinter.com Manuals