Operator`s manual

5-6
Using the Utility Mode
Chapter 5
2. Image Memory Input
Image Memory Input
<Only when the Hard Disk Drive Kit is mounted>
Up to five different, frequently used characters and marks can be stored in memory so you can use them
later whenever necessary.
NOTE
Image Memory Input cannot be set for a job for which the Auto Copy Start setting has been made.
Press the Utility key.
Touch [Job/Image/Scan Input].
Touch [Image Memory Input].
Touch [Input], then touch the desired image
number key, in which you want to store the
image.
NOTE
An image number key not marked with
indicates that an image has already been stored
under that number. If you store a new image in
that number key, the old image is erased.
Select the size of the original, from which to
store an image.
Storing an Image
1
4002O282CA
2
4003P142CA
3
4003P152CA
4
4003P453EC
5
4003P454EB
Downloaded From ManualsPrinter.com Manuals