Service manual

FrameMaker Ver.5.5(PC) Di350 SWITCHES ON PWBs/TECH. REP. SETTINGS
98.11.25
S-18
•
This function allows the Tech. Rep. to make the various settings and adjustments.
<Function>
1. System Set
2. Printer
3. ADFR
4. Scan-through ADF
<Setting Procedure>
1. Touch [Tech. Rep. Choice] to open a screen to Tech. Rep. Choice.
2. Touch the desired major category key.
3. Touch the desired sub-category key.
Tech. Rep. Mode Tech. Rep. Choice
<System Set>
5-4. Settings in the Tech. Rep. Mode
(1) Tech. Rep. Choice
Touch Panel
Display
Setting (The default is ).
Auto Paper Con-
figuration
<Metric Areas>
Select either “Inch/Metric” or “Metric” for rounding off the original size
detected.
<Inch Areas>
Select either “Inch/Metric” or “Inch” for rounding off the original size
detected.
FLS Paper Set the size for FLS.
Simplex/Duplex
Select whether or not to enable the setting of 1-Sided 1-Sided
under Original Copy Default available from User’s Choice.
✽
If “Simplex & Duplex” is selected, 1-Sided 1-Sided becomes
available as an option.
Highlighted
The measurement is rounded to the
nearest standard inch or metric size.
Metric
The measurement is rounded to the
nearest standard metric size.
Inch / Metric
The measurement is rounded to the
nearest standard inch or metric size.
Inch
The measurement is rounded to the
nearest standard inch size.
Inch / Metric
F: 330 mm
C: 203 mm
F: 330 mm
C: 216 mm
F: 330 mm
C: 220 mm
F: 330mm
C: 210mm
Display Duplex Only
Description Does not limit the options for
Original Copy Default to
2-sided copying only.
Limits the options for
Original Copy Default
to 2-sided copying only.
Sim
p
lex & Du
p
lex