Service manual

FrameMaker Ver.5.5(PC) Di350 SWITCHES ON PWBs/TECH. REP. SETTINGS
98.11.25
S-15
5/5
Touch Panel
Display
Setting (The default is ).
Intelligent Sorting When the system is equipped with a finishing option and the ADF is
being used, select whether to turn “ON” or “OFF” the function that
automatically switches between Sort and Non-Sort according to the
number of originals loaded in the ADF.
Output Tray Select the output tray for each application when the system is
equipped with a Job Tray or Finisher.
<Printer>
•
Job Tray
•
Finisher
<Copier>
✽
1: 1st tray; 2: 2nd tray
✽
When the system is equipped with a Finisher, the option of “Copier”
and the tray designation keys “1” and “2” are not displayed.
Small ID Original Select whether to enable (“ON”) a copy cycle or not (“OFF”) when it is
initiated with no original placed on the Original Glass or with an origi-
nal of a small size that is not detectable by the system (smaller than
A5) placed on the Original Glass.
Scanner Dry Set the time-of-day to run a Scanner drying cycle.
✽
When entering a value for Hours and Minutes and if it is a one-digit
number, first enter a “0.”
Density (ADF) Adjust the copy image density level when the Automatic Document
Feeder is being used.
✽
: Initial setting
Highlighted
OFF
ON
2
1
1
2
1
2
OFF
The copy cycle is run using
the paper loaded in the
default paper source.
A warning message is given
and the copier inhibits the
start of this copy cycle.
ON
Hours Minutes
00 ~ 23 00 ~ 59
When the standard original (text, etc.) is
used.
To give better reproduction of a faint origi-
nal.
✽