Service manual

FrameMaker Ver.5.5E(PC) Di350 DIS/REASSEMBLY, ADJUSTMENT

98.12.09

D-54

NOTES

•

If the Imaging Cartridge is not to be replaced after the Master Board has been replaced

with a new one, be sure to remount the EEPROM (IC3A) from the old to new Master

Board.

•

If the Master Board has been replaced with a new one and the EEPROM (IC3A) has not

been remounted, be sure to replace the Imaging Cartridge with a new one. Because the

EEPROM contains no data in this case, make settings and readjustments as necessary.

1. Remove the Master Board. (For details, see 2-2. REMOVAL OF CIRCUIT BOARDS

AND OTHER ELECTRICAL COMPONENTS.)

2. Demount the EEPROM (IC3A) from the new Master Board.

3. Demount the EEPROM (IC3A) from the old Master Board and remount it onto the new

Master Board.

4-2. REMOUNTING THE EEPROM (IC3A)

1171D048AA

New Master Board

New EEPROM

Old Master Board

Old EEPROM

NOTE

Note the alignment notch on the EEPROM (IC3A)

when mounting the IC.

1171D049AA