Service manual

FrameMaker Ver.5.5E(PC) Di350 DIS/REASSEMBLY, ADJUSTMENT
98.12.09
D-48
2. FD
Requirement
1. The difference should be within ±1.0% of the actual length.
2. Adjust so that the following specifications are satisfied with a scale length of 200 mm.
NOTE
This adjustment must be made when the CCD Unit has been replaced and after the adjust-
ments of Registration (CD and FD) (Printer) have been made.
Adjustment Procedure
Zoom Ratio Specification Adjust Mode Setting Range
Full size (×1.000) 200 ±2.0 mm Zoom Adjust (FD) 0.990 to 1.010
1. Place a scale in parallel with the Original Length
Scale and make a copy.
✽
Use the full size (X1.000) mode and paper with a
width of 200 mm or more.
✽
If the scale is of plastic and transparent, place a
blank sheet of paper over it.
1167D112AA
2. Measure the length of the scale on the copy to find
the difference.
✽
If the difference is outside the specification, adjust
by following the procedure shown below.
1134D124AA