Service manual

FrameMaker Ver.5.5E(PC) Di350 DIS/REASSEMBLY, ADJUSTMENT

98.12.09

D-44

2. FD

Requirement

NOTE

This adjustment must be made when the PH Unit has been replaced and after the adjust-

ments of Registration (CD and FD) (Printer) and FD of Zoom Adjust (IR) have been made.

Adjustment Procedure

1. After the adjustments of Registration (CD and FD) (Printer) and FD of Zoom Adjust (IR)

have been completed, produce a test pattern. (For details, see 3-4. TEST PRINT.)

2. Place the test pattern output on the Original Glass and make a copy of it.

3. Check to see if width A on the test pattern copy meets the specifications.

If width A falls outside the specified range, perform these steps to make the adjustment.

Specification Adjust Mode Setting Range

10 ±2.0 mm Registration (FD) -127 to +127

Place the test pattern output after the adjustments of

Registration (CD and FD) (Printer) have been com-

pleted on the Original Glass and make a copy of it.

Adjust so that width A on the test pattern copy falls

within the following range.

1171D007AA