Service manual

FrameMaker Ver.5.5E(PC) Di350 DIS/REASSEMBLY, ADJUSTMENT
98.12.09
D-30
•
Adjustment of the Scanner Motor Timing Belt
3-3. ADJUSTMENT OF BELT TENSION
1. Remove the Original Glass.
2. Remove four screws and the Cover.
1167D014AB
3. Loosen the two screws that secure the Scanner
Motor. Using a bar tension gage, pull the motor to
the right with a tension of 1000 g ±50 g and, at the
same time, tighten the mounting screws.
NOTE
After the adjustment, turn the timing belt to check that
the belt teeth are in mesh with the pulley grooves.
1167D109AB