Service manual

FrameMaker Ver.5.5E(PC) Di350 DIS/REASSEMBLY, ADJUSTMENT
98.12.09
D-20
4. Slide the pulley to the front and install one mount-
ing screw and one E-ring.
1167D073AA
5. Wind the bead end of the cable around pulley D
and pulley C, then hook the bead onto the Adjust-
able Anchor.
1167D056AC
Pulley D
Pulley C
6. Wind the hook end of the cable around pulley A
and pulley B.
1167D057AC
Pulley B
Pulley A
7. Fit the hook end of the cable into the groove in the
Cable Guide and hook the spring.
1167D074AA
Cable Guide
8. Position the round bead of the Scanner Drive
Cable in the pulley as shown.
Rear
1167D051AC