Service manual

FrameMaker Ver.5.5E(PC) Di350 TROUBLESHOOTING
98.12.09
T- 1 7
<Manual Bypass Take-Up Misfeed Troubleshooting Procedure>
Symptom Step Check Item Result Action
Paper is not taken
up at all.
1
Does the paper being used
meet the product specifica-
tions?
NO Instruct the user to use the
paper that meets product
specifications.
2 Is the paper curled, wavy, or
damp?
YES Change the paper. Instruct the
user on the storage of paper.
3 Is the Manual Feed Paper
Take-Up Roller or Roll
deformed, worn, or dirty with
paper dust?
YES Clean or change the Manual
Feed Paper Take-Up Roller or
Roll.
4 Is PC8 fully operational?
Check the input data using I/O
Check.
NO Check the PC8 actuator for
operation and, if it is intact,
change PC8.
5 Check CL3 for operation.
Does the voltage across
CN14-2 and GND change from
DC24V to DC0V when the
misfeed condition is reset?
YES Check various parts for possi-
ble overload and, if they are
okay, change CL3.
NO Change PWB-A.
Paper is at a stop
near the Synchro-
nizing Rollers.
1 Is PC2 fully operational?
Check the input data using I/O
Check.
YES Check various parts for possi-
ble overload and, if they are
okay, change PWB-A.
NO Check the PC2 actuator for
operation and, if it is intact,
change PC2.