Service manual

FrameMaker Ver.5.5(PC) Di350 SWITCHES ON PWBs/TECH. REP. SETTINGS
98.11.25
S-39
•
Adjust mode is for adjustments to be made before shipment at the factory. As a rule, use
this mode only when MFB Board UN2, or EEPROM (IC3A) on Master Board PWB-A has
been replaced with a new one.
<Setting Procedure>
1. Set the copier into the Tech. Rep. mode by the following method:
•
With the Meter Count screen opened from Utility, press the following keys in this order.
2. Enter the Adjust mode by pressing the following keys in this order:
3. Select the particular Adjust mode function to be set.
4. Make the necessary settings by following the instructions given sequentially on the
screen.
✽
The function selected is highlighted.
<Exiting the Mode>
Perform any one of the following steps to go back to the Basic screen.
•
Press the Panel Reset key and Touch [Exit] on the Tech. Rep. Mode screen.
•
Touch [END] on the Adjust mode screen. Then touch [Exit] on the Tech. Rep. Mode
screen.
7 ADJUST MODE
7-1. Adjust Mode Menu Screen
7-2. Adjust Mode Function Setting Procedure
Stop Key
➡
0
➡
0
➡
Stop Key
➡
0
➡
1
Stop Key
➡
Start Key
1167S012CA