Service manual

FrameMaker Ver.5.5(PC) Di350 SWITCHES ON PWBs/TECH. REP. SETTINGS
98.11.25
S-35
•
This function allows the Tech. Rep. to make various settings.
<Setting Procedure>
1. Set the copier into the Tech. Rep. mode by one of the following methods:
A. With the copier turned ON, press the Tech. Rep. Setting Switch.
B. With the Meter Count screen opened from Utility, press the following keys in this
order:
2. Enter the Security mode by pressing the following keys in this order:
3. Select the particular Security mode to be set.
4. Make the necessary settings by following the instructions given sequentially on the
screen.
✽
The Function selected is highlighted.
<Exiting the Mode>
Perform any one of the following steps to go back to the Basic screen.
•
Press the Panel Reset key and Touch [Exit] on the Tech. Rep. Mode screen.
•
Touch [END] on the Security Mode screen. Then touch [Exit] on the Tech. Rep. Mode
screen.
6 SECURITY MODE
6-1. Security Mode Menu Screen
6-2. Security Mode Function Setting Procedure
Stop Key
➡
0
➡
0
➡
Stop Key
➡
0
➡
1
Stop Key
➡
9
1167S011CA