Service manual

FrameMaker Ver.5.5(PC) Di350 SWITCHES ON PWBs/TECH. REP. SETTINGS
98.11.25
S-31
✽
“SMART” is displayed for the inch areas.
Tech. Rep. Mode RD Mode
(8) RD Mode (SMART)
Touch Panel
Display
Setting
RD Mode For making the initial settings of the copier for the Data Terminal.
ID Code Enter a 7-digit ID code (0000001 to 9999999) from the 10-Key Pad to
enable making the following settings. When the ID code is entered
and transmitted after the initial settings have been made, it executes
the transmission of MAINT. START to the Center.
✽
0000000 is invalid.
Maintenance Used to make the initial settings and various transmissions.
DT Setting Enter the following data.
CT-ID
(Password)
Using the 10-Key Pad, enter the 4-digit ID number (0001 to 9999) of
the Center which has been programmed in the Center personal com-
puter.
✽
0000 is invalid.
DT-ID Using the 10-Key Pad, enter the 6-digit ID number (000001 to
999999) of the Data Terminal.
✽
000000 is invalid.
TEL No. Enter the 19-or-less-digit phone number of the modem connected to
the Center personal computer from the 10-Key Pad.
✽
In addition to the 10-Key Pad and Clear key, use the following keys
to enter the phone number.
Interrupt key: For a pause (3 sec. or more), “-”
Pause key: For a pause (3 sec. or more), “-”
P key: For a “pulse” dialing, “P”
T key: For a “tone” dialing, “T”
W key: For a wait code (waiting for a signal from the other party),
“W”
✽
key: For an ISDN subaddress, “
✽
”
# key: For switching from the extension line to outside line, or vice
versa, “#”
Initial Trans-
mission
Used to perform the initial transmission from the copier to the Center
to check for correct communication when the Data Terminal has been
set up.
Counter Clear Used to clear the count of the spare counter set by the Center.
<Procedure>
1. Touch [Counter Clear] to open the Counter Clear screen.
2. Touch the number assigned to the counter to be cleared.
Call Comple-
tion
Used by the Tech. Rep. to notify the Center that his/her service job for
the copier has been completed.