Setup guide

Created by Stacey Hunt

Konica Minolta Hotline Support (UK)

Scanning – Tips & Tricks

FTP

- PageScope Cabinet and the FTP Utility will not run on Windows 2003 & Vista.

PageScope Cabinet needs to be open before scanning, or the FTP Service placed in the

Startup folder of the PC. (see the Konica Minolta FTP & SMB Setup Guide for

Windows)

SMB

* - On Windows 2003, you may find that you need to change a registry setting in order

for this to work. This setting can be found under:

HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Services\LanManServer\Parameters\

RequireSecuritySignature (REG_DWORD)

You need to change the DWORD value from 1 to 0 to disable the SMB digital

communication policy.

* This should only be changed by the customer

- Scanning to a mapped drive – make sure you place a / before the share name of the

folder within that mapped drive.

E-mail

- If you are connecting to an Exchange Server, Relay must be enabled for the Konica

Minolta device on the server itself.

- Alternatively a new account needs to be created on the SMTP server, and

‘SMTP Authentication’ needs to be enabled under the ‘E-mail Transmission’

settings on the MFP.

(Please note that ‘SMTP Authentication’ is not available on all machines)

- In order for ANY Fiery print controller to scan to e-mail, an e-mail account needs to be

set up on the e-mail server as if the machine were a new employee.

- Remember to make sure Binary Division is disabled under the E-mail SMTP Settings.

HDD

- If using the PageScope Box Operator or the HDD TWAIN Driver to retrieve scans,

please make sure you are using the correct version for the version of firmware the

machine is running on.

Version 3.1.0.2 Box Operator should be backwardly compatible with all versions of

firmware.

- Older versions of Box Operator will not connect to newer versions of firmware and need

to be upgraded at the same time as the firmware.

The latest version of Box Operator can be downloaded from our website: