Service manual

FrameMaker Ver5.5E(PC) Di152/Di183 SWITCHES ON PWBs/TECH. REP. SETTINGS

01.07.26

S-9

(2) Drum Dehumidify Mode (Display: U-2)

• Removes dewdrops that have formed on the surface of the PC Drum.

1. Hold down the Panel Reset key for 3 seconds.

2. Enter “2” from the 10-Key Pad. (Display: U-2)

3. Press the Start key. The Drum Dry sequence will be stopped after a given period of

time.

(3) Toner Replenisher Mode (Display: U-3)

• Supply of toner is replenished. The replenishing sequence is stopped after a given

period of time or when a required level of toner-to-carrier ratio is recovered.

1. Hold down the Panel Reset key for 3 seconds.

2. Enter “3” from the 10-Key Pad. (Display: U-3)

3. Press the Start Key.

(4) Custom Size Input Mode (Display: U-4)

• Input the size of the paper loaded in the 1st Tray. (This is necessary when paper of a

nonstandard size is to be used.)

1. Hold down the Panel Reset key for 3 seconds.

2. Enter “4” from the 10-Key Pad. (Display: U-4)

3. Press the Start key. Then, the Display will show the currently set value (in the FD direc-

tion).

4. Press the Clear key to reset the currently set value.

5. Enter the new value from the 10-Key Pad.

6. Press the Start key. Then, the Display will show the currently set value (in the CD direc-

tion).

7. Press the Clear key to reset the currently set value.

8. Enter the new value from the 10-Key Pad.

9. Press the Start key to validate the values entered.

✽

If a value entered falls outside the specified range (paper size), that entry is rejected and

the old value is restored.

• Press the Panel Reset key.

Code No.

Setting (The default is ).

C28 to 33

Allow Paper of same type to be fed from another tray when paper from

one source is empty.

C20: 1st Tray C21: 2nd Tray C22: 3rd Tray

C23: 4th Tray C25: 5th Tray C23: Multiple Bypass Tray

Highlighted

Setting Description

Enables Auto Paper (selection). Enables Auto Tray

Switching.

1 Disables Auto Paper. Enables Auto Tray Switching.

2 Disables Auto Paper. Disables Auto Tray Switching.