Service manual

FrameMaker Ver.5.5E(PC) DIS/REASSEMBLY, ADJUSTMENT FOR Di152/Di183
01.09.03
D-61
(9) ATDC Sensor Automatic Adjustment (F8)
NOTES
• This adjustment is made when the developer has been replaced.
• Make this adjustment with the Toner Bottle removed from the copier.
<Adjustment Procedure>
1. Enter the Function mode.
2. With “F-” shown on the Display, enter the code number “8” from the 10-Key Pad to set
the copier into the “ATDC Sensor Automatic Adjustment” mode.
3. Press the Start key.
✽
This automatically runs the “ATDC Sensor Automatic Adjustment” sequence for about
three minutes.
4. After the F8 operation has been completed, check the adjustment value and enter it on
the Adjust Label.