Service manual

FrameMaker Ver.5.5E(PC) Di152/Di183 TROUBLESHOOTING
01.09.04
T- 1 3
3-3. Misfeed at PC Drum J2
Misfeed at PC Drum J2 Troubleshooting Procedures
• Paper is at a stop at the Synchronizing Roller.
Relevant Electrical Parts
Synchronizing Roller Sensor (PC1)
Fusing Cooling Fan Motor (M3)
Synchronizing Roller Clutch (CL1)
Master Board (PWB-A)
Step Check Result Action
1 Synchronizing Rollers are dirty,
scratchy, deformed, or worn.
YES • Clean or change the Synchronizing
Rollers.
• Clean or change the Paper Dust
Remover.
2 Loop length is set to an appropriate
value.
NO • Adjust loop length using Tech. Rep.
Choice.
• For details, see DIS/REASSEM-
BLY, ADJUSTMENT.
PC1 ANODE
PWB-A
Master Board
TRANSPORT SECTION
FUSING SECTION
Synchronizing
Roller Senser
Fusing Cooling
Fan Motor
Synchronizing
Roller Clutch
4022T523AA