User`s manual
54
Menu On/O Select Conrm Enter 0~9
Installation
Manual Update
1. Select Manual Update and press the OK
button.
2. Enter the options manually
Channel: Select the channel.
Frequency : Enter the frequency. The
corresponding frequency value will be
automatically displayed.
Transmission: Select DVB-T or DVB-T2.
3. Select Search and press the OK button to
search for new software.
4. When new software is detected, select
Ye s to
start the update process now.
Please wait until the update is complete. When
completing the software update, the product
is automatically powered o and on again.
Note:
• It may take 5~10 minutes to update software.
• Other functions such as scheduling programmes will not activate while software update takes place.
• The software updates will only be downloaded over air if you are receiving the HD channels available.
If you do not receive the HD channels at the current time please visit http://www.humaxdigital.co.uk/
update to upgrade via USB.
• Be sure to update software when the signal strength and quality is high. If the weather is not favorable
and the signal strength and quality are not recommendable, perform the software update later.
• The product will search new software automatically during standby. If new software is detected, you
can choose either to download immediately or later when you switch into operation mode. If you
select
Later, the message will be displayed again when you power on.
Caution:
• Please be careful to keep the power on and the power cord plugged in during software update. If the
power is o during software update, fatal damage may be caused to the product.
• Please be careful not to pull out the signal line (RF cable) during software update. Update may be
interrupted and the product may not operate.