Sen Introduction The serviced manual is prepared Tor both skilled technician and grenadier in Introspecting subsequently the method of trouble shooting dispense. ably and repairing IU ds expected fo 6 instructive guilds dor you.
How to Disassembly A. Disassembly of meter = 8 B. Disassembly of the fight side plate ~=o 7 C0 Disassembly of the fhm overwinter dial snd the handle gear base plate =» 8 assembly of the front cover and the shutter holder = BE.
Overall defects detection table F, Winding or film advancing L The film counter cannot be advanced: 2. The film counter being not reset, 3 The warring mark listing hot seen even after the stutter buts sen charged. 4 Coefficient charge.
G, Front holder-quirking 1. Play ia both of the Tater dnd Longitude dirigible directions of the shutter holder {21015 2 Infinity {es} contact helping Improper BH. Viewfinder L 1. Pindar side plate contact when. ope tied and closed.
3, Short circuit 4... Animation of returning of the shirted defended Button & . Heavy resistance in actuating the stop rlug(2003), I Back cover brisk ¢aver.
B. Disassembly of the right side plate 1, Remove the winding handle setscrew {i027 and also the winding Tunnels set (3020 sat) and handle mim washer(3024), 2, Remove the Winding handle reversing button(3080), else twa hunger plate sewers (8008) and take oul {he banger plabef1029 set). 3. Fear off thé right side cover plate leatherette.
€. Disassembly of the film counter dial dnd the handle gear base plate + Disassembly the right side templates item. B. Disassembly «of the fight side plate). Take oi if: the counter dial Duh Séfserawi8005), Hil counter dial Bushido, fim counter dial seb{8201 set] and film counter dial spring 3208) Open the back cover and fake out the reversing Ever axis (3038), middle gear bolder spring, middle gear set{3009 sot] and middle gear holder gut (3206 s8t).
3 AY B. Disassembly of the front cover und the shooter holder «Taw oft the front cover leatherneck, (1536,2157), tale off four setscrews D004) and ths MX, changing knob (2132) so that the front cover secretion% sat) way he taken off: .
i {Dem I E. Disassembly of the back cover Lobster and move CW banger plate scrimshaws (B08) and the back cover fixing metal sef(1115 set), (Either of the right or left members may be taken off).
so fe F. Winding or film advancing 1. Tre film counter can not be advanced © a) Engagement of the middle gear (8208) with the film counter dial (3201). Adjust the cont face of the middle ger holder(3298) and body sup fads. When fhe actuation of the middies gear householder) is found to be wrong, adjust so that the smooth action ay be obtained. (see 41 bi The middle gear (3209) being in comet with the counter reverse ever (iim.
3. properly: If counter geese lever is working wot Staunchly tan he raids bY binding Bhi don lack face between the middies gear holder and Goldwater reverse lever, bY Disconnection of the Hla copywriter SHA] spending (3205, # Loosening of the counter dial bgh wetness (9005) Rotate the counter dialectal) surmount clockwise well 4t stops and then rotate also the counter dial Lush 3208) counter clockwise by a quarter of the disfranchisement (oom its original place And hed tighten ihe dial Bush setscrew (9005).
ci 4 4. Unscientific shutter charge : ay The crank arm adjusting platelet) i lowered doo. much so that ile crank arm MELEE cannot actuate properly. Af the position where 1 Is possible to charge for the infinity and for the near distance; HEE the crank aim adjusting splatted) about 1.2 to LF sus and tighten the adjusting plate at this positive. AJ his Lime indite handle must rattan Shortly, by The ease in which the convectional of the shutter Installation of hag much play.
View-finder Ti Rubs when opened and dosed; &) The outer frame robs with the Fig. 18 front side plate : Adjust so that the front side plate may be placed ab the equidistant exposition an relative both to the outer and inner frames. tb he back side plate rubs with the honer frame: Adjust so that the back side plate sin tet contact With the nine frame. outer frame: 4 Front. side plate #2: Ammunition of opening und dosing of the viewfinder, a) Disconnection of the front side Lite proportion innerspring) Fig.
or BG i. Shutter Ro ‘The shutter rouse bunion hellion not valence. a) Thy fs Bechtel the para lie. Hem between the contact faces of ihe shinier Holder (2401) and the charge sing {20195 Adjust the parallelism of the surface of the shutter Bolder an that the actuation may Be effected smoothly Ih this case, confirm their the focusing i$ Fight.
A. Malfunction of returning of the shutter released button, a) The release lever Bl springiness) is foo wel ao halt 18 wist be string: thane . I} Dieting between the shutter release bunion (2001) and the shutter release bitten Bush (2002) 1s roper; Take off the hastier release button bush(2002) @nd wake a reaming of it by serer. £) Wash foreign material Is mixed in between the shutter release butted (2001) and th shatter release ration lean it nif.
im GY #: Much podded between the tamers body und the bask covey Whig 44 caused by the pied at the wore Portion oo i , Fig: 92 of the back cover, The direction of installing the hack cover fitting. wielder must desalinized with the Body sack arrow directions : over La! K. Focus adjustment Fe.
