Installation guide

Unpacking and setting up
2
2-15
Connecting the power cable
Only use the power cable supplied with the printer.
The laser printer requires a power supply with minimal voltage and
frequency fluctuation. If necessary, ask an electrician for advice.
4 Power supply: 120-127 V at 50-60 Hz / 220-240 V at 50-60 Hz
4 Voltage fluctuation: 120V -10%, 127 V +6% / 220-240 V ±10%
4 Frequency fluctuation: Within 3 Hz
1
Make certain that the printer's
power switch is in the “0” (OFF)
position.
2
Insert the plug on the end of the
power cable (supplied) into the
power socket of the printer.
3
Insert the other end of the power cable into a power socket.
CAUTION
Using the wrong power cable may cause a short-circuit!
Using power cables of inadequate cross-section can lead to overheating
of the cable.
Ü Only use an extension cable which has a higher rating than the current
consumption of the printer.
Ü Only use cables with a ground connection.
Ü Always observe the relevant local regulations regarding the
connection of electrical equipment to the main power.