Installation guide

2
Unpacking and setting up
2-10
2.4 Please note the following points:
What should I watch out for when loading paper?
To avoid paper misfeeds in the laser printer, please observe the following
points:
l Do not use any paper with the following features:
m Paper that has already been used in a thermal or ink-jet printer.
m Paper that is too thin or too thick.
m Folded or wavy paper.
m Paper having binding holes or perforations.
m Paper with a surface that is too smooth, too rough or irregular.
m Specially coated paper such as carbon paper or paper with an
adhesive surface.
m Paper that is not cut at right angles.
m Paper that is held together by glue, adhesive or clips.
m Paper with labels that detach easily.
m Warped or curled-up postcards.
l Please note that the stack of paper in the paper tray should not exceed
the “max.” mark.
.
Note
When paper is loaded, the orientation is based on the format marks in
the paper source units.
What should I watch out for when loading envelopes?
To avoid envelope misfeeds in the laser printer, please observe the
following points:
l Do not use self-adhesive envelopes or those with a tear-off strip,
closures or a window.
l Place the envelopes in the tray long edge first.
l Place the envelopes in the tray with the flap down so that the upper
surface of the envelopes is lying against the side of the tray with the
feed roller.
l Load envelopes of format B5 with the flap facing down and pointing to
the rear of the tray.
l Make certain that the flaps are neatly folded back.