User`s guide

Setting up the printer
2
2-9
Connecting the power cord
WARNING
Use only the power cord shipped with the printer. Using the wrong
power cord may lead to a short-circuit!
The use of a power cord of inadequate cross-section can lead to a short-
circuit.
➜ Onlyuseanextensioncablewhichhasahigherratingthanthecurrent
consumption of the printer.
➜ Only use grounded cords.
➜ Always observe the relevant local regulations regarding the connec-
tion of electrical equipment to the main network.
This laser printer requires a non-fluctuating power supply. If necessary,
ask an electrician for advice.
✔ Voltage: 110V - 10%, 127V + 6%, or 220-240V ± 10%
✔ Frequency: 50-60Hz ± 3Hz
1
Make sure that the printer’s power
switch is in the “O” (OFF) position.
2
Connect one end of the power cord
to the power cord socket on the
back of the printer, and plug the oth-
er end into a power outlet.
EDNord - Istedgade 37A - 9000 Aalborg - telefon [phone]