User`s guide
1
@k/kÂÝkÂÌÅÎ@@ÎÌ@bÌ3Åk¿ÅÌ×bk}Ê
Version—Identifies the ImageServer and TIFF versions.
»Note:
The Version submenu is not available on the 2060, 2425, 3260, 4032, 4060,
magicolor 2, magicolor 2+, magicolor 330 or magicolor 6100. (Instead, the
ImageServer version is printed in the Options section of the printer’s start-up page.) A
PostScript file on the printer’s hard disk also contains the ImageServer version
number. Remote users can retrieve the sys:/bin/emulate/isver.ps file via ftp and then
either look at it or print it to get the current ImageServer version.
Each submenu, except Version, has a comparable Document Option Command (DOC),
which overrides the configuration menu setting. (For more on DOC, see the
Crown
Document Option Commands
manual, on the
Software Utilities
CD-ROM.)
»Note:
The ImageServer Option must be installed before it can be configured. If it has not
been factory installed, refer to chapter 2, “ImageServer Installation,” for installation
instructions.
Î@Î
This submenu has two options—QMS Tag# and State.
»Note:
For information on annotating TIFF images, see the FastPrint Printer Driver on-line
help. For more information on accessing annotation features within TIFF, see the
ImageServer Developer’s Kit User’s Guide.
QMS Tag #
Purpose
Identifies the annotation tag number.
Menu
Administration
Emulations
TIFF
Annotation
QMS Tag#
Choices
0-65000
1000
(Default in Bold)
Notes
Unless it conflicts with your host software, we recommend that you use the default
setting of 1000, the MINOLTA-QMS private tag number.
DOC %%IncludeFeature:QMStag(
#
)