User`s guide
ÅÎ@@ÎÌÎÌ@bÌ
kÅÎ@@ÎÌxÂÌ
@ÅÌ.$!
@k/kÂÝkÂÌÅÎ@@ÎÌ@bÌ3Åk¿ÅÌ×bk
Õ¥æ
,QVWDOODWLRQWRDQG'HLQVWDOODWLRQ
IURP)ODVK520
1060, 1060E, 1660, 1660E, and 1725E only
These procedures are used to install/deinstall the ImageServer Option to printers that
store the option in flash ROM. For procedures used to install/deinstall the Image-
Server Option to printers that store the option on a hard disk, refer to “Installation to
and Deinstallation from Hard Disk” on page 2-3.
»Note:
The following installation and deinstallation procedures apply to printers
connected via parallel port, serial port, or network connection.
,QVWDOODWLRQ
»Note:
Installation of the ImageServer Option in printers that store the option in flash
ROM requires that the printer’s system software be reloaded with system software that
includes the ImageServer Option. This is the software supplied with the ImageServer
Option.
1 To remember any custom printer configurations or options that you want to
reset after the new software has been loaded, print an advanced status
page.
This installation procedure will reset all configurations and options presently set in
your printer to their factory default values.
2 Install the ImageServer Option by following the instructions in your printer
documentation for updating system software.
You’ll be using the Administration/Miscellaneous/New Flash Image menu to
update the system software (image in flash ROM).
After the printer reboots, the start-up page lists its new name (for example, 1660E
ImageServer), and the ImageServer Option is listed in the Administration/Emula-
tion configuration menu.
3 Increase the printer’s K Mem Emulation client (Administration/Memory/K
Mem Emulation) by at least 1 MB or, for optimum performance, by 2 MB.
»Note:
See your printer documentation for more information on memory clients
and on using your printer’s configuration menu.