User`s guide
ÅÎ@@ÎÌÎÌ@bÌ
kÅÎ@@ÎÌxÂÌ
@ÂbÌÅ
@k/kÂÝkÂÌÅÎ@@Î Õ
3 Change to that drive (for example, if the CD-ROM is in the D drive, type d:↵
at the DOS prompt).
4 If you’re downloading the deinstallation file (is-del.ps) from a UNIX worksta-
tion, copy the file from your PC to a temporary directory on your worksta-
tion.
5 Make sure your printer is on line, and that the printer’s message window
reads IDLE.
6 Open an ftp session from your PC or workstation by typing one of the fol-
lowing commands:
ftp
printername
↵ (for example, ftp pctdev6↵)
ftp
ipaddress
↵ (for example, ftp 161.33.130.45↵)
7 When prompted for a user name and password, press the Enter key.
If your entries are correct, an ftp> prompt displays.
8 At the ftp> prompt, change to binary mode by typing
bin↵
9 At the ftp> prompt, send the deinstallation file to the printer’s hard disk by
typing
put is-del.ps↵
The ftp> prompt returns when the deinstallation file has finished loading.
10 At the ftp> prompt, end the ftp session by typing
quit↵
11 When the Disk light stops flashing and the printer’s message window reads
IDLE, the printer automatically reboots.
The start-up page lists the printer’s original name (for example, 3260).
»Note:
If you have a 2060, 2425, 3260, 4032, 4060, magicolor 2, magicolor 2+,
magicolor 330, or magicolor 6100, the start-up page no longer lists the
ImageServer version (in the Options section).
»Note:
You may want to erase any deinstallation files left on your PC (and/or
workstation), and then remove any temporary directories.