Installation Sheet

Fig 19

INSTALLING THE LED LIGHT KIT

NOTE:

Before starting installation, make sure power is turned off at the circuit breaker.

1. Remove 1 of 3 screws from the mounting plate and loosen the other 2 screws. (Do not remove)

2. While holding the LED light kit under the fan motor assembly, make the 2-pin wire connections: (Fig. 19)

- White to white

- Black to black

3. Place the key holes in the LED light kit over the two mounting screws previously loosened from the

mounting plate. Turn the LED light kit until the LED light kit locks in place at the narrow section of the

key holes. Secure by tightening the two mounting screws previously loosened and the one previously

removed. (Fig. 19)

SCREWS

CONNECTORS

LED LIGHT KIT

MOUNTING

PLATE