Instruction manual

ELECTRICAL CONNECTIONS

WARNING:

To avoid possible electrical shock be sure electricity is turned

off at the main fuse or breaker box before wiring.

NOTE: The Aire Control

System is equipped with a learning frequency

function which has 256 code combinations to prevent potential

interference from other remote units. The frequency on your Receiver

and Transmitter units have been preset at the factory. (Fig. 14) No

frequency change is necessary, should you desire to install another fan

within the same home or area with a seperate frequency code please see

the "frequency interference" troubleshooting section of this instruction

manual to learn how to change the frequency.

Step 1.

Attach receiver to the motor housing using the double sided

tape pre-attached to the receiver. (Fig. 15)

Step 2. Motor to Receiver Electrical Connections: Connect the WHITE

wire from the fan to the WHITE wire marked "TO MOTOR N" from the

Receiver. Connect the BLACK wire from the fan to the BLACK wire

marked "TO MOTOR L" from the Receiver. Connect the BLUE wire from

the fan to the BLUE wire marked "For Light" from the Receiver.

NOTE: If your ceiling fan features an UP Light: Connect the ORANGE wire

from the fan to the ORANGE wire marked "For Up Light" from the

Receiver. Otherwise disregard this step and proceed to secure all wire

connections with the plastic wire nuts provided. (Fig. 16)

Note: Fan must be installed from a maximum distance of 40 feet from

the transmitting unit for proper signal transmission between the

transmitting unit and the fan's receiving unit.