Instruction manual

WARNING: All of the parts, hardware and components such as the hanger

bracket and hanger ball have been provided for your safety and the

proper installation of your new ceiling fan. The use of other parts,

hardware or components not supplied by Minka Aire

with the fan will

void the Minka Aire

Warranty.

REMEMBER to turn off the power. Follow the steps below to hang your

fan properly:

Step 1. Secure the Hanger Bracket to the ceiling outlet box using the screws

provided with your outlet box in conjunction with the lock-washers

provided with the fan. (Fig. 8)

Step 2. Loosen the two Set Screws and remove the Hitch Pin and Lock Pin

from the coupling located on the top of the Motor Assembly. (Fig. 9)

Step 3. Remove the Hanger Ball from the Downrod Assembly by loosening

the Set Screw and removing the Cross Pin. (Fig. 10)

Step 4. Carefully feed fan wires up through the downrod. (Fig. 11)

Thread Downrod into the Coupling until the holes are lined up and

secure with the Lock Pin and Hitch Pin previously removed, tighten

Set Screws. (Fig. 12)

Step 5. Slip Coupling Cover, Canopy Cover and Canopy onto

Downrod. Carefully re-install the Hanger Ball onto the Downrod

being sure that it's properly positioned over the Cross Pin and the

wires are not twisted, tighten Set Screw.

Place downrod rubber cover

onto the hanger ball,

(Fig. 12)

Step 6. Lift the Motor Assembly and place the Hanger Ball into the

Hanger Bracket. Rotate the Motor Assembly as needed until the check

groove from the Hanger Ball rests firmly over the registration tab

from the Hanger Bracket. Motor Assembly should not rotate if this is

done correctly. (Fig. 13)

HANGING THE FAN