Instruction manual

4
Step 1. (Fig. 5) Remove the metal plate and
upper cover by remove the screws from the
motor.
Step 2. (Fig. 6) Insert the blade through the
access window from the blade holder. Align
holes from the blade and motor and secure with
screws with lock washers and blade support
plate. Repeat process with the other blades.
Step 3. (Fig. 7) Replace the upper cover and
the metal plate to the motor and secure with
the screws previously removed.
NOTE: Please adjust the angle of reverse
switch holder before replacing the upper
cover if the switch does not align to the hole
on the upper cover.
Fig. 5
Fig. 6
BLADE INSTALLATION
Fig. 7
SCREWS
UPPER
COVER
METAL
PLATE
SCREWS WITH
LOCK WASHERS
BLADE
SUPPORT
PLATES
BLADE
UPPER
COVER
METAL
PLATE
SCREWS