Installation Guide

INSTALLATION INSTRUCTIONS
For Model 71216-143C
WAR N ING ! SH UT P O WE R O F F AT F US E O R CI R C UI T B RE AK E R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
Fig. 1
Fig. 2
HANGING THE FIXTURE (Fig. 1)
1. Shut off the power at the circuit breaker and remove
the old fixture including the mounting hardware.
2. Carefully unpack your new fixture and lay out all the
parts on a clear area. Be careful not to lose any small
parts necessary for installation.
CONNECTINE THE WIRES (Fig.2)
3. While supporting the fixture, connect the electrical
wires as shown in figure 2. If your post has a ground
wire (green or bare copper), connect the fixture ground
wire to it. If not, consult your electrician for proper
grounding. After the wires are connected, tuck them
carefully inside the post (D).
COMPLETING THE INSTALLATION (Fig. 1)
4. Take off the roof (A) by loosening two screws (B),install
the bulb (E12 Candelabra, not supplied) in accordance
with the fixture’s specification. Attach the roof (A) back
to the cage (C) by two screws (B).
DO NOT EXCEED THE MAXIMUM WATTAGE
RATING! (NE PAS DEPASSER LA PUISSANCE
NOMINALE MAXIMALE!)
5. Place the fixture onto post (A), and secure with the 3
mounting screws (B)
Your installation is now complete. Return power to
the junction box and test the fixture
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
White
(Neutral)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
Green or
Bare
Copper(G
round)