Installation Sheet

INSTALLATION INSTRUCTIONS
Item#2759-694 (New.2022/04/18)
READ AND SAVE THESE INSTRUCTIONS
W A R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
Fig. 1
Fig. 2
HANGING THE FIXTURE (Fig. 1)
1. Shut off power at the fuse box or circuit breaker box
and remove the old fixture including the mounting
hardware.
2. Carefully unpack your new fixture and lay out all the
parts in a clear area. Take care not to misplace any
small parts necessary for installation.
3. Thread screws (A) into pre-drilled holes in circular
strap (B). Spaced the same distance apart as the
holes in the canopy (D). The length of screws (A)
may be adjusted if necessary.
4. Attach the circular strap (B) to junction box (not
included) using mounting screws (C) (Size:
#8-32N*L0.5”). The side of the circular strap (B)
marked “GND” must face out.
CONNECTING THE WIRES (Fig. 2)
5. Connect the electrical wires as shown in Fig. 2,
making sure that all wire connectors are secured. If
your junction box has a ground wire (green or bare
copper), connect the fixture’s ground wire to it.
Otherwise, connect the fixture’s ground wire directly
to the circular strap (B) using the green screw
provided.
6. Tuck wire connectors neatly inside the junction box.
COMPLETING THE INSTALLATION (Fig. 1)
7. Slide screws (A) into canopy (D) and secure with
knobs (E).
8. Install (2) two medium base bulbs (F) up to 60 watts
each or CFL or LED equivalent (not included) in
accordance with the fixture specification—DO NOT
EXCEED THE MAXIMUM WATTAGE RATING! (NE
PAS DEPASSER LA PUISSANCE NOMINALE
MAXIMALE!).
9. Thread all thread (J) to coupling (H) and tighten with
hex nut (I). Adjust hex nut position if necessary.
10. Place metal tube (K), metal cover (L), plastic
washer (M) over all thread (J) and secure with hex
nut (I).
11. Place glass shade (N)) over all thread (J) and
secure with finial (P).
12. Secure the pine cones (G) to the metal sticks on
the fixture body.
Your installation is now complete. Return power to the
junction box and test the fixture.
Note: Illustration (Fig.1) on this manual is for
installation purposes only. It may or may not be
identical to the fixture purchased.
LA-3558E
Set
#
A
-
020
-Circular Strap
-Ground screw
-Mounting Screw*2
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
White
(Neutral)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
Green
(Ground)
MIN 90℃ SUPPLY CONDUCTORS
J
K
I
A
B
C
D
E
F
H
I
L
M
N
P
G