U.S.
This product is protected by United States Federal and/or State Law, including Patent, Trademark and/or Copyright laws. Manual design and all elements of manual design are protected by U.S. Federal and/or State Law, including Patent, Trademark and/or Copyright laws.
SAFETY RULES 1 BLADE AND LIGHT CAP INSTALLATION 8 PACKAGE CONTENTS 2 INSTALLING THE LIGHT BULBS & GLASS SHADES 9 INSTALLING THE FAN 3 OPERATING THE REMOTE CONTROL/WALL CONTROL 10 HANGING THE FAN 4 CARE OF YOUR FAN 11 ELECTRICAL CONNECTIONS 5 TROUBLESHOOTING 12 INSTALLING THE WALL TRANSMTTER 6 SPECIFICATIONS 13 FINISHING THE INSTALLATION 7 1151W.
ATTENTION: The Energy Policy Act of 2005 requires this fan to be equipped with a 190 watt limiting device. If lamping exceeds 190 watts, the ceiling fan’s light kit will shut off automatically. NOTE: The important safeguards and instructions appearing in this manual are not meant to cover all possible conditions and situations that may occur. It must be understood that common sense, caution and care are factors which can not be built into this product.
2 PACKAGE CONTENTS Unpack your fan and check the contents. You should have the following items: 1. Fan blades (5) 12b.Wall Plate w/2 Mounting screws 2. Mounting bracket 13. Extra wall plate 3. Canopy 14. Bulbs (3) 4a. Standard downrod assembly 15. Balancing Kit 4b. Minimum-length downrod (for close A. Mounting Hardware: to ceiling mounting only) #8-32X3/4” Machine scews (2 pcs) 5. Coupling cover #8X 1 12 ” Wood screws (2 pcs) 6. Glass shades (3) Flat washers (2 pcs) 7.
4 HANGING THE FAN screw,removing the cross pin,and sliding ball off rod.(Fig 7) Step 4. Carefully feed fan wires up through the downrod (Fig 8). Thread the rod into the coupling, line up holes and replace lock pin and hitch pin.Tighten set screws. Step 5. Slip coupling cover, and canopy onto downrod (Fig 8). Carefully reinstall hanger ball onto rod being sure that cross pin is in the correct REMEMBER to turn off the power.
9 INSTALLING THE LIGHT BULBS &GLASS SHADES NOTE: Before starting installation, make sure power is turned off at the circuit breaker. ATTENTION: The Energy Policy Act of 2005 requires this fan to be equipped with a 190 watt limiting device. If lamping exceeds 190 watts, the ceiling fan's light kit will shut off automatically. Step 1. Remove the 3 screws from the light cap. Step 2. Connect the white connectors from the light kit and fan, do the same with the black connectors. Step 3.
speed settings for warm or cold weather depend on factors such as room size, ceiling height and number of fans. NOTE: To change the direction of the rotation of the blades the fan must be in operation mode. Warm Weather (forward) A DOWNWARD airflow creates a cooling effect as shown in Figure 22. This allows you to set your air conditioner on a warmer setting without affecting your comfort. Cool Weather (Reverse) An UPWARD airflow moves warmer air off the ceiling area as shown in Figure23.
TROUBLESHOOTING SYMPTOM SYMPTOM Fan will not strart Fans/Light Turn on SOLUTION and Off 1. Check to make sure the wall Unexpectedly switch is turned on. SOLUTION 2. Check circuit fuses or breakers. 3. Caution! Make sure the power is 1. This is caused turned off before performing the by interference, following steps. change the code 4. Remove canopy and check wire frequency from connections. the transmitter, 5. Check wall control transmitter and follow the connections ( if applicable).
