User`s manual

MINIX
890GX/880G-USB3 User's Manual
- 28 -
►
Onboard Device Conguration
Click <Enter> key to enter its submenu.
BIOS SETUP UTILITY
Advanced
Onboard Device Configuration DISABLED: disables the
integrated IDE Controller.
PRIMARY: enables only the
Primary IDE Controller.
SECONDARY: enables only the
Secondary IDE Controller.
BOTH: enables both IDE
Controllers.
←
Select Screen
↑↓
Select Item
+- Change Option
F1 General Help
F10 Save and Exit
ESC Exit
Onboard PCI IDE Controller
Hard Disk Write Protect
IDE Detect Time Out (Sec)
ATA(PI) 80Pin Cable Detection
Serial Port1 Address
Onboard Lan Controller
Onboard Lan2 Controller
Onboard Lan Boot Rom Control
►
USB Device
[Both]
[Disabled]
[35]
[Host & Device]
[3F8/IRQ4]
[Enabled]
[Enabled]
[Disabled]
v02.61 (C)Copyright 1985-2006, American Megatrends, Inc.
• Onboard PCI IDE Controller
This option allows you to Select PCI IDE training mode
• Hard disk write protect
Disable/enable device write protection.this will be efctive only if device is accessed through
BIOS
• IDE Detect Time Out
Select the time out value for detecting ATA/ATAPI device(s)
• ATA(PI) 80Pin Cable Detection
Select the mechanism for detecting 88pin ATA(PI) Cable.
• Onboard Floppy Controller
Allows BIOS to Enable or Disable FLOPPY Controller
• Serial Port1 Address
Allows BIOS to Select Serial Port1 base Addresses.