User manual

Reading the Advanced Variables

Reading these variables is done by entering

0-111 according to the programming button

hence

Address 00

Max. speed 1

Delay 1

Pulse width 1

Stop section 1

and pressing the programming button.

Writing the Advanced Variable

Note:

2 stop sections must always be set in order to program the

advanced variables!

Writing these values is done by entering

00 = VAI according to the programming button

hence

Address 00

Max. speed V (Velo)

Delay A (Acce)

Pulse width I (Impw)

Stop section 2 (Stop)

and pressing the programming button.

The values to be entered for the VAI are explained in the

following:

Note:

If the motor “whistles” after being placed into operation,

then you probably forgot to enter the standard values again.

Swapping Connections (Velo)

If you should have swapped the connections on open

decoder wiring, you can “adjust” this electronically. First

check which connections need to be swapped, and then

enter as a value the number that can be taken from the

following table:

Motor Light Track Number

x x – 7

– x – 6

x – – 5

– – – 4 (standard)

x x x 3

– x x 2

x – x 1

– – x 0

Note:

Swapping the connections for the motor or the track will

lead to corresponding changes in analog operation.