User manual

MWIPC-1510WG User Manual

SSID The SSID (up to 32 printable ASCII characters) is the unique

name identified in a WLAN. The ID prevents the unintentional

merging of two co-located WLANs.

You may specify a SSID for the card and then only the device

with the same SSID can interconnect to the card. If you want to

add one of the networks nearby to the profile list, pull down the

menu, all the networks nearby will be listed and you can add one

of them to the profile list.

Channel This setting is only available for Ad Hoc mode. Select the number

of the radio channel used for the networking. The channel setting

should be the same with the network you are connecting to.

Basic Rate The camera will force to the data rate that you selected to

transmit data.

Authentication and

Encryption Type

Choose the authentication type you want to use.

“None” means that you don’t want any encryption for wireless.

“Open System” means that you can use WEP for encryption or

not to encryption. When you select “Shared Key”, you must use

WEP for encryption. The last option is “WPA-PSK”. When you

select this authentication type, you can encryption your wireless

with WPA-TKIP or WPA-AES.

WPA Pre-Shared Key The WPA-PSK key can be from 8 to 64 characters and can be

letters or numbers. This same key must be used on all of the

wireless stations in the network.

WEP Key Length You may select 64-bit or 128-bit to encrypt transmitted data.

Larger key length will provide higher level of security, but the

throughput will be lower.

WEP Key Format Hexdecimal – Only “A-F“, “a-f“ and “0-9“ are allowed to be set as

WEP key.

ASCII – Numerical values, characters or signs are allowed to be